4.2 Zebra410 Printer
Introduction
-
The Zebra410 printer is mainly used to print label
-
Open the printer
-
The primary operator controls are found on the front of the printer. The indicators may be off (not lit), red, green, or yellow. The indicators can blink or remain on in a variety of patterns that denote various printer activities or status
Setup
-
Need an Android phone with NFC, download App: Zebra printer Setup Utility
-
Initial interface of APP
-
Pairing with the mobile device
-
Pairing successful
-
At the same time, the printer network identification will turn green
-
Click Connectivity Settings and join a WIFI (Notice: Printer and Handhold controller must be connected to same WIFI)
-
The following steps are shown in Section 2.3. The operation is carried out on Handhold controller
Paper Setup
-
Open the printer. Pull the release latch levers toward the front of the printer
-
Open the media roll holders. Orient the media roll so that its printing surface will face up as it passes over the platen (drive) roller. Pull the media guides open with your free hand and place the media roll on the roll holders and release the guides. Verify the roll turns freely. The roll must not sit in the bottom of the media compartment
-
Pull the media so that it extends out of the front of the printer
-
Push the media under both of the media guides
-
Close the printer. Press down until the cover snaps closed
-
Paper Roll Specifications
-
Purchase link:https://www.amazon.com/Thermal-Perforated-Barcode-Compatible-Printers/dp/B07QY487BC/ref=sxin_3_ac_d_pm?ac_md=1-0-VW5kZXIgJDUw-ac_d_pm&cv_ct_cx=zebra+label&keywords=zebra+label&pd_rd_i=B07QY487BC&pd_rd_r=9cef44c2-4485-474b-9832-410e55bebaea&pd_rd_w=Bw1Gr&pd_rd_wg=ZBT5l&pf_rd_p=aba5dc0d-7593-4752-a14d-357ecc5c98cc&pf_rd_r=QV00XQMGKAPXH9MTRP5S&psc=1&qid=1578767708