4.1 Star Printer
Introduction
-
Star printer is mainly used for kitchen orders
Setup
-
Connect power cable
-
Turn power on
-
When the power is turned on and it can be used normally, the Ready LED turns on blue
-
Connect to the network. Press and hold the PAIR button until the LED (blue) button of the printer blinks
-
Press the WPS button of the access point or router
-
When a network connection is established, print out the connection details, and the LED of the printer will stop blinking and stay lit
-
* When connection cannot be established, repeat the steps above (Notice: Printer and Handhold controller must be connected to same WIFI)
-
The following steps are shown in Section 2.3. The operation is carried out on Handhold controller
Paper Setup
-
Push the opening lever to open the printer cover
-
Set the paper roll in the direction as shown in the illustration
-
Pull the end of the paper straight out, sandwich the paper and close the printer cover. The setting is completed when the paper is cut automatically
-
Push both sides as shown in the diagram and close the printer cove
-
Paper Roll Specifications
-
Purchase link：Purchase Link